Archimedes' screw

Archimedes' screw, also called the Archimedean screw or screwpump, is a machine historically used for transferring water from a low-lying body of water into irrigation ditches. The screw pump is commonly attributed to Archimedes on the occasion of his visit to Egypt, but this tradition may reflect only that the apparatus was unknown to the Greeks before Hellenistic times and introduced in his lifetime by unknown Greek engineers, although some writers have suggested the device may have been in use in Assyria some 350 years earlier.

Design

Archimedes' screw consists of a screw (a helical surface surrounding a central cylindrical shaft) inside a hollow pipe. The screw is turned usually by a windmill or by manual labour. As the shaft turns, the bottom end scoops up a volume of water. This water will slide up in the spiral tube, until it finally pours out from the top of the tube and feeds the irrigation systems. The screw was used mostly for draining water out of mines or other areas of low lying water.

The contact surface between the screw and the pipe does not need to be perfectly watertight, as long as the amount of water being scooped at each turn is large compared to the amount of water leaking out of each section of the screw per turn. Water leaking from one section leaks into the next lower one, so that a sort of mechanical equilibrium is achieved in use.

In some designs, the screw is attached to the casing and they both rotate together instead of the screw turning within a stationary casing. A screw could be sealed with pitch resin or some other adhesive to its casing, or cast as a single piece in bronze. Some researchers have postulated this as being the device used to irrigate the Hanging Gardens of Babylon, one of the Seven Wonders of the Ancient World. Depictions of Greek and Roman water screws show them being powered by a human treading on the outer casing to turn the entire apparatus as one piece, which would require that the casing be rigidly attached to the screw.